Author: laxkid13
Subject: Re-configuring USB Device
Posted: 31 Jan 2013 04:13:37 pm (GMT -5)
Hello there,
I have been very interested in this project since its first announcement back in 2011, and have been planning to have a go at ever since. Just recently i got a graphlink cable and began to explore the code. My issue is that i don't have the specific afterglow controller used in the project, and was wondering how exactly i would go about re-configuring the code to support the controller or devices i would like to use. Unfortunately i have been looking around and realized that this project hasn't really picked up much steam, and haven't seen any one else tinkering around with the code. My hope was that if i found a post i could figure it out from there. Can either of you two be of any assistance? It would be greatly appreciated!
Thanks in advance,
Vince S.
Subject: Re-configuring USB Device
Posted: 31 Jan 2013 04:13:37 pm (GMT -5)
Hello there,
I have been very interested in this project since its first announcement back in 2011, and have been planning to have a go at ever since. Just recently i got a graphlink cable and began to explore the code. My issue is that i don't have the specific afterglow controller used in the project, and was wondering how exactly i would go about re-configuring the code to support the controller or devices i would like to use. Unfortunately i have been looking around and realized that this project hasn't really picked up much steam, and haven't seen any one else tinkering around with the code. My hope was that if i found a post i could figure it out from there. Can either of you two be of any assistance? It would be greatly appreciated!
Thanks in advance,
Vince S.
